Recent content by amrogers3

Ok, thanks for the infos. That lead me to do some more troubleshooting. I have two NIC cards in my pfsense firewall. I opened 37777 for the other NIC and used that network to connect DMSS. It works. I have no idea why DMSS is dying after 30 seconds on the other one. I don't see anything in the...

I googled this but couldn't find an answer. I am using DMSS (1.99.710) on an iPad and using the camera's IP to connect. It connects and live view works but then after about 15-30 seconds it stops. It never reconnects after it stops. Is there any way to configure DMSS to run a continuous feed...

I am going to keep an eye on it and see how it handles the light transition from day to night. Thanks again for the help.

Thanks for y'alls help. Hopefully this clears up the issue. Won't really know until dusk tomorrow, that's usually when the flickering starts.

I tried that on both and it appears to be working. I'll have to run it for a few days like this to see if it glitches.

Hi Bigfish. yes it is the Boobiecam. It looks like biggen suggestion seems to work.

This is a Dahua IPC-HDBW5441F-AS-E2-2.8mm Started a while back. Usually starts when dusk hits and stops after it is completely dark. I turned off IR completely and it is still flashing.

I can't figure this out. I messed with ALL of the "condition" settings and nothing is working. This happens when dusk hits and the IR kicks on. I tried google with no luck but maybe I am not searching the correct issue. Any suggestions on what settings to adjust or what to google to figure out...

@looney2ns I do have alarm wires connected on this camera. I can take the camera down and look to see if any are touching. Might be hard to see though. Thanks

I've been dealing with this for a while. The alarm will randomly kick on during the day. I don't have any triggers set during daylight hours. I have several cameras connected to a Dahua NVR. I checked the log on the NVR and it shows this: I am not sure I am reading this correctly. Does this...

Ok, I'll give a factory reset a shot. I think I tried that before and had this same issue. It was a while back so I can't really remember.

Appears to be 4MP per the information tab. Also, should I update the firmware on this guy? Latest firmware was released May 2023.

Yes, I am using IE 11. FPS to 5 doesn't do anything. I have IVS rules set up on Channel 1 but I can't create a rule on Channel 2.

Got an issue with setting up IVS on channel 2 on IPC-HDBW5441F-AS-E2. IVS is enabled. but when I try to click the + to set up an IVS rule, it does nothing. Tried to reset to default and save and save failed. Anyone else encounter this issue? I did a search for this issue on here but...

@EyeOfSauron did you find a solution that works?