Recent content by AstroIROC

No these aren't Chinese cameras, US versions. I did finally get the browser\web interface to work, the problem being that the Webcomponent.exe needed to be installed, after that the browse button worked. I was able to update the firmware on the 2 cameras that were not up to date which were also...

I have 2 of these cameras in a friends system using BI. The passwords continuously reset. Not sure if someone is access them or what. I have changed the password several times to strong passwords and these 2 out of 6 cameras always reset after a week or so. At least I have found a rest tool that...

TY I will go through of the wiki too. I have several of these systems that I manage. So I'm not new to BI, but there is a lot to learn Thanks again

Yes the cameras and PC are wired to the switch and then to the router. TY

Thank you I'm working on it. TY TY

Thank you they are now!! CPU dropped tp 8-10 percent. now trying to enable Quick Sync TY Ty

I'm having an issue with a new system/install. Dell i7-10700, 12Gb Ram, 512 SSD m.2, 4Tb purple drive, 5 HikVision DS-2CD2343G0-I 2.8MM cameras, full version Blue iris 5.5.1.5 x64, The issue is the CPU runs about 60-70 %, and all cameras are like slow motion and about a 1-2 minute lag, I have...

Darn, wishing I saw this before I bought the Amcrest. But I have it set up now and is working fine TY

TY for the reply, I have ordered the Amcrest from the IPCamTalk store

Ty. I usually use Hikvision cameras, but I have a request for a WiFi camera that will sit on a mantle. What would you recommend?

Does anyone know for sure that they will work with Blue Iris. Thanks in advance

This ended up being that the foam ring around the camera lens had shrunken away from the dome lens, letting in the IR light. I fixed this by cutting off the foam ring and shimming it up by gluing a piece of foam pipe insulation under it to space it out against the dome lens again. It works...

I have a few systems that are set up using Hikvision cameras in Blue Iris. Several cameras (DS-2CD2132F-I) and similar models that look terrible at night. Looks like the IR is bouncing around in the dome and reflecting bad. They Look real foggy looking. Am I missing something in the settings?

After setting BI to run as a service, reduced live preview frame rate, and video scaling, it now is running in the 50-60 % range Thank you everyone.