Recent content by CA50

Thank you @TonyR , but my ezviz C3WN model doesnot seem to have any web GUI. Same is try to the NVR as well. The NVR as #80 open but which redirects to a index.asp with following error message

Hello, Can you tell me which file to modify to see all the settings ? Also is there any way to see the advance options for the cameras which are connected to the NVR. I can see the camera options only for those camera which are connected to my router and not to the ezviz NVR.

Anyone with this link ?

The problem was with my router. Changing it has fixed the IP Camera detection issue

I can see and have enabled ONVIF in the camera settings. Also i have enabled ONVIF in the NVR. Both the NVR and IP camera are connected via the same router. I have connect the IP camera via LAN, then NVR can detect and display the image. In case of wifi, the NVR cannot find it. No, this was...

Auto detect: Wifi cams are not detected Manual: (Device mode) : Not connected error (ONVIF) : Not connected error In the camera configuration, the ONVIF port is set as 8080, i am using the same. Also i checked with ONVIF Device Manager and entered the correct URL, but no...

Sure, my blinking issue was because of corrupt EEPROM, I solved by following these stesp 1. flashing EEPROM with the attached file using CH341 programmer 2. After restart, NVR hangs at boot logo and restart 3. Updated firmware normally using USB (new firmware link...

Latest update. Issue fixed. I am able to boot into my NVR. Thank you all for your inputs.

The earlier problem was because i have flashed the wrong firmware from NVR8. After flashing with the correct one , the boot process works but it gets stuck here. RAMDISK: gzip image found at block 0 update_logo 12 uncompression error update_logo 13 VFS: Mounted root (ext2 filesystem) on device...

I tried your steps setenv bootcmd 'showlogo;startvo 0 36 13;mw 0x200300b8 0x0ff0f0ff;sf probe 0;sf read 0x81000000 0x100000 0x380000;sf read 0x82000000 0x480000 0x280000;bootm 0x81000000 0x82000000' saveenv At this point if i do printenv, i can see the values in env, but if i restart the...

I am reflashing the EEPROM, once done i will run your commands and will share the result

Actually i tried all the steps, but it didn't help. Sent from my ONEPLUS A3003 using Tapatalk

Which all file should i place in it? I tried this but it didn't do anything.

This is the output of the tftp command hisilicon # tftp Hisilicon ETH net controler MAC: 00-00-23-34-45-66 UP_PORT : phy status change : LINK=DOWN : DUPLEX=FULL : SPEED=100M UP_PORT : phy status change : LINK=UP : DUPLEX=FULL : SPEED=100M TFTP from server 192.168.1.2; our IP address is...

This is the output of printenv bootargs=mem=96M console=ttyAMA0,115200 bootdelay=1 baudrate=115200 ethaddr=00:00:23:34:45:66 ipaddr=192.168.1.10 serverip=192.168.1.2 netmask=255.255.254.0 bootfile="uImage" jpgLogoAddr=0x60000 jpgLogoLen=0x20000 jpgLogoW=800 jpgLogoHetenv=logo_addrF00000...