Recent content by Chase

Im done trying for tonight. Need a break. Is there a specific pivpn you like? Amazon?

Ok i'll have to figure out how to log into the modem because access is denied when i type the IP address in. I know how to port forward on the Eero though.

Still working through it. If "Main Router" is considered the Eero Pro 6 then I would have to put the Brume after the Eero, I think? I also understand I'd need to port forward the Brume to the Eero. The question I have I think, don't I need to change the IP of the Brume to match the IP series...

So do you think I need to update the IP of the brume to match my local LAN IP because it's different right now with the Brume being 192.168.8.1. I believe I can port forward the Brume from the Eero app

Also not sure if I need to port forward anything anywhere. What I typed out above is all I’ve done so far

So I went with the Brume 2 unit, hooked the WAN cable from the modem to the WAN cable on the brume, then the lan from the br to the computer. Set up just fine, logged in fine, setup WireGuard fine and installed on phone. It says it has connection but I can’t get back to my network. I probably...

I’m still trying to figure all this out. Just wish there was a simple solution. I’m tempted to just port forward but I know everyone says not to. What would you say is the best pivpn (without WiFi) that won’t break the bank. Best place to buy as well. Amazon? Or would this be the way to go...

Forgot to mention that I run a dahua nvr and not blue iris. Not sure if that changes anything.

So I just switched from cable to frontier fiber optic now using the Eero Pro 6e mesh system. On my old setup I was using the Asus RT-AC1750 router which has the built in OpenVPN server. I want to keep using OpenVPN so I can keep my cameras offline from the internet and not port forward them...

The NVR is connected to the switch. Bottom switch, top row, all the way to the right.

Thank you for the replies. Good suggestion on moving the switch link to the uplink port on the 2nd switch. I know the pic can be kind of confusing. Did the best to label the ports

Attached is the picture of what I have setup. I am just wondering if this was the way you connect 2 switches together? And since we are here, does everything else look like its set up right? Wasn't exactly sure if they had to be in specific spots or not.

Hey guys looking for some help here. I have this camera set up and running on my bench for testing. Problem is I only have 1 of the camera feeds showing. Not sure how I get the other one to come up. In the NVR, I’ve been looking at the modify camera page but all I see is 1 channel and can’t...

Don’t know if this would still matter but I know my iPad shared the same IP address as the camera did. 192.168.1.108 I have since changed the ip of my iPad but nothing is different.

Took the camera down to bench test with a store bought cable and same thing happens. I suspect the camera is bad as I can’t even log into it. Am I out of luck? I imagine that in order to update the software I would need to log in first.