I would like to share my experience.
I think the software transfer is the easiest with the CH341A programmer and SOP8 DIP8 test clip.
I spent a lot of time with the other methods.
You can read everything in the posts, it's really not hard.
The hardware you get cheap at the China-shops.
:iloveipct:
Good news!
The system is running again. I did not believe it anymore ....
Many thanks for your help!!
I've written the flash sw-nd6004-h1-2.0-128M from V1.0.1.5927 and it worked.
This file does not exist in the V1.0.1.6964, is that the reason why the update did not work?
I have now written all 4 files individually, without success.
The programmer does not give an error message verify is ok. I think the file I need is composed of the individual.
Serial I get no answer. As I said the led does not light up that means the board has no bootloader, I think.
No, I did not decode the firmware.
Unfortunately, I do not know how to do that.
Verify failed! chip with the contents are in disagreement!
What can I do now?
There is another problem.
the red led next to the main cpu no longer lights, I think the bootloader is no longer available.
I have both files written without success.
So, I am back...
I have now received the programmer and the clip.
The software is installed and the chip is recognized.
Which firmware do I have to flash now?
The numbers are verry smal, what i can see, on the
chip bottom right:
25L12......
M2I-1...
80286...
L16......
chip top right
....09
402...
3 chips on the left with the same numbers
FR9886
G1608
L849D