Recent content by Ronmac

  1. R

    Sadp not pulling any ips

    Laview which I believe are rebranded Hik
  2. R

    Sadp not pulling any ips

    Grids not grades
  3. R

    Sadp not pulling any ips

    I had to update the firmware to get the email working for motion detection. But now the cameras need to be updated because the motion detection grades aren't working right. That's why I need the IP address of each camera to update their firmware. I didn't realize this was an issue until I had...
  4. R

    Sadp not pulling any ips

    I'll try and see how it goes. Thanks.
  5. R

    Sadp not pulling any ips

    Will that remove a firmware update I installed as well?
  6. R

    Sadp not pulling any ips

    I think I found the ips with angry ip tool with a laptop plugged into nvr poe port. but can't log in via I.E. they seem to ping ok if that's what they are.
  7. R

    Sadp not pulling any ips

    My nvr only shows Mac addresses for each cam.
  8. R

    Sadp not pulling any ips

    If I do one at a time I can see a generic ip through a search or as an Ovnif in the nvr list and log into the cam via I.E. Was hoping to have something to read all the ones plugged into the nvr. Can't even get the nvr to show on the sadp tool.
  9. R

    Sadp not pulling any ips

    Bump. Anyone have any suggestions?
  10. R

    ONVIF 2.4 POE camera for my LV-N9916C6E NVR system

    What ip search tool did you use. I can't get sadp to work with mine.
  11. R

    Sadp not pulling any ips

    Have to update my cameras firmware. In the nvr I just see Mac addresses I assume. I have a camera hooked up to a poor injector with one and into the router and I'm using my PC which is hooked up to my router I downloaded winpcap and sadp. I open SID pay it just stays blank even when I...
  12. R

    DDNS Question

    I can try that next if it doesn't work. So I would reserve in the router and change the DHCP back in what - the NVR?
  13. R

    LaView LV-N5216D6E Request for Expertise

    The cameras all list the same sender IP address, subnet mask, gateway and dns servers. They all have what seem to be different MAC addresses perhaps. I do not see different ip addresses for each camera anywhere.
  14. R

    LaView LV-N5216D6E Request for Expertise

    Hmmm. SADP tool won't do anything when connected to NVR. Changed IP address to one in the DHCP range where I presume the cameras are and tried one near the NVR.
  15. R

    DDNS Question

    Set range to end 200. Attempted to change NVR IP , Subnet mask and Gateway to 192.168.1.201 and get a config save failed. It changed in the Verizon Fios router to .201 though. The IP will stay changed in NVR but Subnet and Gateway revert back to what was there before
Top