BI Camera Clone

I’ve created 4 clones on one camera to have a PTZ move to four different zones on trigger.
One of the clones, the fourth, is using bitrate the same as the camera cloned from. The others are not using any. They are all set up the same, I can’t see any difference in settings that would cause the one to act differently. I do notice the three not using any bitrate have a astric * after their shortname at the top of the live view window, the fourth does not.

I purchased a “refurb” Dell Optiplex 7020 i5-4590 with 8gb ram, 500gb hdd and W10 pro.
I swapped the hdd for a 250gb ssd and installed a 2tb hdd. I did a clean install of W10 pro on the ssd. Had a couple 4gb ram sticks laying around, so pulled 2 2gb’s out and now have 12gb ram. There was 1 4gb stick and 2 2gb sticks. Deactivated BI off old pc and installed on new-old one and imported the settings. Everything seems to be working other than the one clone using bitrate.
This “refurb” was very clean, not a speck of dust on the inside, couple minor scratches.

Any ideas about the one clone?

Screen shot of the BLUE IRIS camera status screen, with all cameras and clones .

I went ahead and deleted Clone4 to see if resetting it would do anything. Clone3 took its place as using bitrate.
Set up Clone4 again and 3 is still using bitrate. Guess that's just the way it is.

What happens when multiple zones are triggered simultaneously?

PTZ looks like its trying to keep up with a cat with a firecracker taped to its tail.

Strange, I have no idea on this one. Maybe try a different version and see if it's a possible glitch?