Search results

  1. G

    Intercom VTH5221DW with VTO2111D-WP

    I finally got the system working vi wired network (direct connection for now since I cannot get switch between them yet). WiFI was working but besides bad video it was unreliable. At times the VTO would not reconnect which is not acceptable. The WIFI signal is quite strong, so that is not the...
  2. G

    VTO2111D turn card reader off

    Is it possible to turn the (rf?) card reader off? I believe it is interfering with my gate's remote control. When the VTO2111D is on, the remote control can open/close the gate only if it is about 4m away. When the VTO is off the same remote control works on up to 20m distance. Thanks!
  3. G

    Intercom VTH5221DW with VTO2111D-WP

    Thanks @Tsarsky! That did work. I think clearing history and cookies may be enough as I noticed changing the IP address to what it was before displayed the old page. After clearing browser history the page appeared as expected.
  4. G

    Dahua IPC EASY unbricking / recovery over TFTP

    Thanks @riogrande75 hips, VDPconfig did the job.:goodpost:
  5. G

    Intercom VTH5221DW with VTO2111D-WP

    @Gabor I just got it working with 888888 as password. I was using the VTOConfig. @Tsarsky I upgraded to the version you provided but I don't' see the Transmission Mode option.
  6. G

    Intercom VTH5221DW with VTO2111D-WP

    Hi, I'm having the same issues and it'll be difficult to get wired network in my case. The whole reason for buying this products was the WiFi capability. On top of all that I cannot upgrade the VTO from v2.2, it rejects all firmwares. The VTH upgraded to 3+ and now when I try to upgrade it to 4...
  7. G

    Dahua IPC EASY unbricking / recovery over TFTP

    I already tried using the Config Tool (I'm guessing VDPconfig is same as Config Tool?) and it fails every time. I managed to upgrade the VTH but VTO would not accept. I did try few firmwares and no luck at all. Interesting thing with the VTH is that it upgraded to 3.<not sure>, but now when I...
  8. G

    VTO2111D-WP bricked, won't recover

    Hi Diego, I'm trying to upgrade my VTO2111D from v2.2 to 3.12 or 3.3 (with SIP) but I don't seem to be able to get the connection going. I'm using Mac and Windows is running in VM. Tried running tftp server on both OSs and no luck. Connection is direct using ethernet cable. What am I missing?
  9. G

    Dahua IPC EASY unbricking / recovery over TFTP

    Hi, newbie here. I have been trying to upgrade the firmware on my VTO2111D following the instructions at the beginning of this thread with zero success. I simply cannot get any connection to the tftp server. I connected the VTO directly to my laptop using ethernet cable. IP addresses where...
Top