42212TNI - help me find a setting please

[marklyn]

Going bonkers here in trying to find a setting and could use some help.
I can't figure out where the setting is that moves the camera back to a preset position after 30 seconds of inactivity when I'm manually moving the cam around.
For example. I move the cam to a different position manually and if I leave it alone for 30 seconds it defaults back to one of my preset positions.
I looked under idle motion, which is set to go to a preset after 25 mins so that's not it.
It's not under the powerup area.
The time task autoHome setting is set for 1200 seconds so that's not it either.
I would think it would be under the idle motion area but instead of moving after 25 minutes it moves to preset after 30 seconds.
What am I missing?

 

[looney2ns]

Thats odd.
Have you tried setting it back to factory defaults and starting over?
You've covered the places that would be causing it.

 

[marklyn]

No I haven't tried resetting back to factory. Hate to do that and set everything back up but that may be my last resort. I was hoping someone would point out something obvious that I missed.

 

[marklyn]

Figured it out and big duh on my part.
I have a time task #2 where one of the settings is auto home and it was set for 30 seconds there.
So my time task #2 is for nighttime (7p-7a) and when that task was activated, so was the 30 second auto-home.
I just didn't notice that each task had an auto-home setting.