I just did the most recent update a couple of days ago to 4.6.2.1 and all my cameras are either getting the No signal error or the color bars. Has anyone else seen this error and if so where you able to correct it? If I bring up each individual camera properties and then verify the link under the video tab all of them come up in a browser, as they should, with no issues.
All cameras stopped
- Thread starter revtmyers
- Start date
fenderman
Staff member
- Joined
- Mar 9, 2014
- Messages
- 36,902
- Reaction score
- 21,274
what cameras? what settings? h.265 or h.264...
11 cameras total of various kinds. One is just a PI camera just doing MJPG stream... and I kid you not I have rebooted that system umpteen times as well as the network and as I am typing this I looked over and after 22 hours the just all came back on. Which still does not give me a warm fuzzy feeling since I don't know why. Been using them for around 2 years with no issues. Anyhow besides the PI camera I use:
1 Sunba 507-20XA-P2P
1 ACTi E77 10MP
2 Foscam FI9821PV2W
1 Foscam FI9805W
1 Foscam PI9805P which all the Foscams are H.264
1 FI9821PV2W
1 Amcrest ProHD Outdoor 3-Megapixel (2304 x 1296P) IP3M-943W
1 Sumpple S631W
and a couple more indoor PTZ cameras that are Foscams but don't remember the models.
1 Sunba 507-20XA-P2P
1 ACTi E77 10MP
2 Foscam FI9821PV2W
1 Foscam FI9805W
1 Foscam PI9805P which all the Foscams are H.264
1 FI9821PV2W
1 Amcrest ProHD Outdoor 3-Megapixel (2304 x 1296P) IP3M-943W
1 Sumpple S631W
and a couple more indoor PTZ cameras that are Foscams but don't remember the models.