Bug in 5.2.7.2 - motion detector and substreams?

joshwah

Pulling my weight
Joined
Apr 25, 2019
Messages
298
Reaction score
146
Location
australia
Hi,

It seems there is a bug with the sub streams and motion detection. Is it a bug or a misunderstanding on my end?

Steps to replicate:

1. Create zones under primary stream … say half the screen.

2. Couple of motions get detected etc… normal behaviour.

3. Activate sub-stream

4. If you look at the motion detections, it all looks normal.. i.e. if you enable “test run through motion detector” it all looks normal with the zone only showing and the other half being blacked out. Great!

5. If you go into edit the motion zones, it does not show the motion zones… so if you try to add a new motion rule, it will not go live.. it will always revert back to the motion rule created under the primary stream created earlier…

6. Even if you delete the sub-stream entry so it reverts back to the primary only stream… and then enter the zone motion detector, it will still will not let you edit the zone.

One thing I did notice is when I go into editing the motion detector, it shows down the bottom, “Active Zone map: \Motion\1” I am guessing this may relate to stream 1 = primary?

Hope this makes sense.. but yes, very annoying :(
 
Top