Does anyone know how to connect Dahua nvr2108hs-8p-s2 via telnet
Firmware : 3.205.0 build 2017-10-13
When I scan the open ports on my nvr I don't have telnet 23 open (see nmap result below)
My nvr nvr2108hs-8p-s2 is connected standalone behind a raspberry pi and I don't have access to the web interface of the nvr but only ssh on the raspberry pi, that's why I would like to connect to nvr via telnet on the raspberry pi command line for parameter changes.
Any advice would be welcome
Thx
Firmware : 3.205.0 build 2017-10-13
When I scan the open ports on my nvr I don't have telnet 23 open (see nmap result below)
Nmap scan report for Dahua_NVR (192.168.1.15)
Host is up (0.0045s latency).
Not shown: 65531 closed ports
PORT STATE SERVICE
80/tcp open http
554/tcp open rtsp
8686/tcp open sun-as-jmxrmi
37777/tcp open unknown
My nvr nvr2108hs-8p-s2 is connected standalone behind a raspberry pi and I don't have access to the web interface of the nvr but only ssh on the raspberry pi, that's why I would like to connect to nvr via telnet on the raspberry pi command line for parameter changes.
Any advice would be welcome
Thx