IVS on Dahua NVR Doesn't Show or Work

chris11c

n3wb
Joined
Aug 5, 2018
Messages
23
Reaction score
3
Location
USA
I have a Dahua NVR model NVR5216-16P-4kS2E with the following specs:
Web Version 3.2.3.98477
Onvif Version 2.4.1
System 3.216.000000.0 Build Date 2018-05-30

NVR and one camera from below are from October. The other two were ordered back around end of Novemeber.
I have 3 total IPC-HDW5231R-ZE 's right now. Everything was ordered form Andy of course.

My goal is to have IVS tripwires setup as my cameras are under my overhangs and rain sets off the motion detection bad.
So...
I have IVS tripwire on all the cameras but only one camera works correctly. The other two do not show the rules on the live view as an overlay. I can see the IVS rules in the IVS setup area. I have tried my best to duplicate the working camera to the other cameras but to no avail. I have even cracked one open and factory reset it, I have reset both to factory through their interfaces as well. Nothing seems to work. I set the IVS rules like I said but they do not trip like on the first camera. I set the trip wires and crossed them, but not alerts. I do not have the smart codec enabled. I am out of ideas as one camera works perfectly and all are very similar.

Camera 1
System Version2.622.0000000.31.R, Build Date: 2018-08-13
WEB VersionV3.2.1.616707
ONVIF Version16.12(V2.4.3.574996)
Safe Baseline VersionV1.2
This camera does not work correctly.

Camera2
System Version2.622.0000000.31.R, Build Date: 2018-08-13
WEB VersionV3.2.1.616707
ONVIF Version16.12(V2.4.3.574996)
Safe Baseline VersionV1.2
This camera works correctly

Camera 3
System Version2.622.0000000.31.R, Build Date: 2018-08-13
WEB VersionV3.2.1.616707
ONVIF Version16.12(V2.4.3.574996)
Safe Baseline VersionV1.2

Any help would be great appreciated, I've been at this for two days now.
 

BillG

Getting the hang of it
Joined
Nov 6, 2015
Messages
178
Reaction score
83
Have you tried setting up the cam's ivs on the nvr? How are you viewing the nvr? directly or the web interface?
 

chris11c

n3wb
Joined
Aug 5, 2018
Messages
23
Reaction score
3
Location
USA
Thank you for the reply. So I fixed it.
I ran a hdmi cable to my nvr to the tv.
Under Events, Smart Plan, I had the IVS LightBulb unselected for the other cams somehow. After selecting this for the other two cameras, IVS works perfectly. Hope this helps someone.
 
Top