Motion Detection only triggering while on Configuration page

ChadMabry

n3wb
Joined
Dec 16, 2016
Messages
2
Reaction score
0
I've got two cameras set up in front of my house. While looking at the primary Blue Iris screen with both camera's live feed displayed, neither camera will trigger to record when there is motion out front.

However, if I open Camera Properties > Trigger > Configure Motion Sensor and then walk out through the front of my house, the recording will trigger and I can come back in and watch myself cross the front yard.

If I save settings and walk back through the front yard, the recording will not trigger from motion detection.

I can manually trigger it and manually record, but unless I'm looking at the Motion Sensor Configuration page the recording will not trigger.

What gives?
 

fenderman

Staff member
Joined
Mar 9, 2014
Messages
36,897
Reaction score
21,250
post screenshots of all your settings...check traffic signal and profiles.
 

ChadMabry

n3wb
Joined
Dec 16, 2016
Messages
2
Reaction score
0
I figured it out! Woo.

Solution: Camera Properties > Schedule > Tick box: Override global schedule for this camera

Both cameras were perpetually set to an Inactive state, even if the correct profile was selected in the Profile Menu at the top right portion of the main screen.
 
Top