Some Ideas to improve reliability of my IP cam network

[IpCamEnthusiast]

Have been thinking about how to make my system more reliable. I have made the following changes, wanted to hear if these are good ideas and if there are other things I can do
1) Replaced my non solid copper (CCA) wire with solid copper wire
2) Heat sealed my connections to cameras
3) Installed POE extenders for all my runs over 300 ft

These steps are helping. Were they good ideas? Are there other similar upgrades I can make? I still am getting a bit of spotty coverage on my 24 cam setup with about 10 runs that are over 400 ft.

*my POE extenders are bv-tech singe port gigabit POE+ Extender from amazon
**my solid copper ethernet cables are monoproce 1000ft 24AWG Cat53 350MHz UTP solid from amazon as well

 

[GCoco]

Sounds good. Have you thought about lightning protection for outdoor runs or runs between buildings? Also I use Tycon Systems POE extenders that run about 500 feet and no a single problem. Using an UPS for your NVR or PC?

(POE-EXT-GD-HP) Outdoor Gigabit PoE Extender, 802.3at in/out extends Ethernet and PoE an extra 100M