Hello,
i cant found somewhere a tutorial to remove the settings from the device.
Here is a tutorial:
1: Buy a USB UART TTL
2: Turn the device off and open the recorder
3: Connect the pins from J6 to the UART TTL
4: Pin 1: TX, Pin 2: RX, Pin 3: GRD
5: Start Putty or Tera Term and open the comx (x:number), set Baudrate to 115200
6: When the caption "Hit any key to stop autoboot" shows up, press ***.
7: Enter eracfg and press enter
Done
i cant found somewhere a tutorial to remove the settings from the device.
Here is a tutorial:
1: Buy a USB UART TTL
2: Turn the device off and open the recorder
3: Connect the pins from J6 to the UART TTL
4: Pin 1: TX, Pin 2: RX, Pin 3: GRD
5: Start Putty or Tera Term and open the comx (x:number), set Baudrate to 115200
6: When the caption "Hit any key to stop autoboot" shows up, press ***.
7: Enter eracfg and press enter
Done
