37777 is a comm/TCP port for cameras NOT connected to the internal switch.
When connected to the NVR switch, they use a simple Port 1,2 3, etc
Here shows a mix of both. The 192.168.1.X cameras are on an External switch. This is how they should look on a PoE NVR, Usually you see cameras using the internal switch with 37777 port is because they were manually moved or added from the top pane to bottom. If you just plug them in and leave them be, they'll migrate to the bottom pane with Port 1 etc
Hi bigredfish
I understand what your suggesting.
The image from the NVR is that he's using the virtual IP assignment of the NVR itself, hence the 37777 and 10.... assignments for the dahua standard communication protocol for the Dahua cameras.
Yes but it won’t work with using 37777 on the internal NVR PoE switch
Need to unplug them, plug back in one at a time, and allow them to register (move to bottom) by themselves. Do not manually add them
They should be using ports 1,2,3 etc
Just installed the 2022-11-15 firmware, figured it wouldn’t let me roll it back but worked fine. I lost IVS notifications. Reinstalled the 2023-12-5 firmware and IVS notifications started working again. Again I don’t know where I found it but shows I downloaded it on 1/23/24. Still doesn’t make sense because I’m sure the 5232-16P-4KS2E I purchased from EmpireTech on 6/29/2022 always had IVS notifications working fine with P2P disabled. Maybe the firmware it shipped with worked and I never updated until the 2023-12-5 but seems like it had the 2022-11-15 when I went to the 2023, can’t recall on that.
Hi, so your NVR 5216 now has IVS notifications working by using a 2023-12-5 firmware even without P2P enabled?
I have Dahua DHI-NVR5216-4KS2 V2.00 and IVS notifications always worked without P2p and im on old System Version:V3.216.0000006.0Build Date:2019-02-23. Since half a year ago IVS suddenly stopped sending notifications and I've tried everything. Maybe I need to upgrade to latest firmware?
Just checked it's: 4.002.0000000.6R build 2022-11-15. Think it's the latest and most likely the last. Think it was version .3 some time ago that caused the issue with no IVS notifications, unless P2P was active. Standard motion/SMD is not a problem with P2P disabled.
OK thanks for reply. Finding firmware prob wouldn't be a problem I'm just thinking if I need to do some consecutive updates to get it to that version or just jump straight to that version since I have old Version 3.216.