So today we had a whole house fan installed in our attic, plus a bunch of insulation blown in. When they were blowing in the insulation after the fan install, I lost signal to one camera. Five minutes later, I lost signal to my remaining 3 cameras all at once.
All four cameras are HDW5231R-Z plugged into a BV-Tech 16 Port PoE+ Switch via cat6 cable. All of my connections at the switch look good, just no green status port light. I haven't been in the attic yet to check my wires. Other than my cables being cut, any other suggestions? Interference?
Thanks,
Mark
All four cameras are HDW5231R-Z plugged into a BV-Tech 16 Port PoE+ Switch via cat6 cable. All of my connections at the switch look good, just no green status port light. I haven't been in the attic yet to check my wires. Other than my cables being cut, any other suggestions? Interference?
Thanks,
Mark