Hi all,
We had our roof replaced above where 2 cameras sit. It rained between tearoff and getting all the flashing back up and 2 of the cameras got wet. They are Hikvision 3MP turrets, the rj45 connectors show burns on the jack and the patch cable. The camera also shows the same I replaced the patch and the rj45 jack and tested it. My Zyxel switch shows fault as the port status. I plugged in an old Dahua to test and it comes up without issue.
I am considering cutting the plug off the Hikvision and replacing it since I do not have a power supply to test if the PoE portion is fried or not.
Any suggestions?
We had our roof replaced above where 2 cameras sit. It rained between tearoff and getting all the flashing back up and 2 of the cameras got wet. They are Hikvision 3MP turrets, the rj45 connectors show burns on the jack and the patch cable. The camera also shows the same I replaced the patch and the rj45 jack and tested it. My Zyxel switch shows fault as the port status. I plugged in an old Dahua to test and it comes up without issue.
I am considering cutting the plug off the Hikvision and replacing it since I do not have a power supply to test if the PoE portion is fried or not.
Any suggestions?