Never mind I fixed it. The HP ProCurve switch is
more than adequate. You just have to be smart enough to use it. After thoroughly reading the manual my problem is resolved. For anyone interested the HP ProCurve switch is an enterprise level switch that also has layer 3 switching. Configurations are near endless, and can be had for $39 on Ebay. Pretty damn good deal considering 12 poe+ ports plus 12 reg ports.
HP ProCurve J9624A 2620-24 PoE+ Ethernet Network Switch w/ Ears - Rack Mountable | eBay
Long story of it is the switch was trying to conserve power to the device and only give it what was needed at the minimum. This works fine for the small cams that don't have the current draw of a larger cam with motors that are activating a different times. The port was going down on over current. The ports are all individually configured. The port my ptz is on is now configured properly. Proof is in the puddin. The screen shot below is with the cam hooked up a pre made piece of
cat5e shielded 500 foot long. The amp draw only increased 25mA from a 10 foot piece of cat6.
If anyone needs any help on configuring the HP switch I would be more than happy to assist. I can not speak to those switches I'm unfamiliar with.
View attachment 55165