Recent content by 105437

  1. 1

    Bitrate setting on my 54IRs, can it be too high and effect BI performance?

    Thanks, how about H.264H vs. H.264? I appreciate your reply!
  2. 1

    Bitrate setting on my 54IRs, can it be too high and effect BI performance?

    I'm working with Ken right now to troubleshoot a performance issue when viewing the live stream of a camera in UI3. Here is my main stream encode setting used on all of my 54IRs. Would I lose any noticeable picture quality by reducing the Bit Rate to 8192 or 4096? How about the Compression...
  3. 1

    Struggling to dial in front door camera settings to improve quality

    Walking. Dialed exposure to 0-7 and will monitor. Thanks again!
  4. 1

    Struggling to dial in front door camera settings to improve quality

    Okay, I've settled on these settings for Day. Image is pretty good considering the camera being used. I appreciate the advice from everyone!
  5. 1

    Struggling to dial in front door camera settings to improve quality

    I tried flipping it 90°, but it said that wouldn't work due "The function cannot be supported by the resolution."
  6. 1

    Struggling to dial in front door camera settings to improve quality

    D Different cameras from my situation and the image looks much better than my wedge.
  7. 1

    Struggling to dial in front door camera settings to improve quality

    No changes other than using SSA for Backlight.
  8. 1

    Struggling to dial in front door camera settings to improve quality

    Here's the new snapshot capture with the setting below.
  9. 1

    Struggling to dial in front door camera settings to improve quality

    Thanks for the reply. Here is the FOV of one of the cameras. All of these entry points are under a covered porch, so it's always shady. I'll try your number and send a new capture.
  10. 1

    Struggling to dial in front door camera settings to improve quality

    I have 3 IPC-E35IR-AS-3.6mm cameras from Andy @EMPIRETECANDY installed at each of my entry doors to the house. Clip and snapshot image capture is great at night. Daytime capture, particularly early morning and at dusk, is not so great. The snapshot image shows some motion blur and a little dark...
  11. 1

    Queue JPEG Post stopped working

    I have an event scheduled on each camera to save a JPEG every day at sunset. I've been using this event for years and then I noticed yesterday that none of the cameras successfully stored the event in the destination. I scheduled another event to test this morning, and it didn't work. I even...
  12. 1

    EmpireTech 10th Anniversary (Summer+Prime Day)Sales

    Congrats on 10 years, Andy! Just purchased 6 tickets... let's go!
  13. 1

    How to re-trigger when using ONVIF alerts from the camera?

    I was using Intrusion boxes for detection. I added several trip wires to the field of view for the area inside the intrusion box. Seems to work well for me.
  14. 1

    How to re-trigger when using ONVIF alerts from the camera?

    I use AI detection from my 54IRs to trigger alerts for people and wildlife. Sometimes the subject stays in frame for a while. Is there a way to have BI to continue to record the main stream until the subject leaves the FOV? Thanks