Recent content by BHj

Thanks @EMPIRETECANDY - what new features does it bring?

So, seems there are now both General_SD5AXXX-HN_MCU_V2.401.0000000.98.R.210402 and DH_SD-Prometheus_MultiLang_PN_Stream3_V2.810.0000025.0.R.210317 on Dahua firmware site for SD5A445XA-HNR. @pinko so did you install the new FW:s? Any differences you noticed? @EMPIRETECANDY is the firmware...

Have not looked into that yet, but I did use some command to stop the motion detection. Can't remember right now, but can see if I can find it later.

Hi. I have the same need, and think I figured out how to do it on at least my SD59225 First use a browser to check which rule you want to enable/disable; http://<camera ip>/cgi-bin/configManager.cgi?action=getConfig&name=VideoAnalyseRule Then you enable/disable the rule in question by setting...

As mentioned in email, but also for others that might try it out; the implementation of 49225 in the new version of the app that is just out does not work well. Somehow the inclusion of my proposal has not come through as expected. I have sent a new version, based on the "basedOn" which should...

How about the /cgi-bin/configManager.cgi?action=getConfig&name=Lighting ? I get (as example) table.Lighting[0][0].Correction=50 table.Lighting[0][0].FarLight[0].Angle=0 table.Lighting[0][0].FarLight[0].Light=50 table.Lighting[0][0].MiddleLight[0].Light=0...

In the DH-SD49225T-HN there are all in all 6 IR lights, of which the intensity for the 2 lowest ones are controlled via /cgi-bin/configManager.cgi?action=setConfig&Lighting[0][0].NearLight[0].Light=xx ..and the 4 upper ones via...

Can't recall if it was using oldfashioned Wiresharking, or if I found those interpolating from the settings backup file. The settings backup file is essentially like an encoding of everything that can be set.

Hi @alexvas, I wanted to add some commands to my new Dahua SD-49225T-HN. Worked pretty OK on the basics with one of the Dahua models, but thought I would notch it up a bit using the basedOn directive in the custom_vendors.xml setup. Unfortunately tinyCam seemed not to allow me to do so, saying...

Hi guys. I have a Dahua DH-SD49225T-HN. I wanted to get better control over the IR leds, and did not really like having to mess around with the day and night mode. I am not sure if this will help you, but I experimented a bit and found the following things to work for my purpose. These are not...