Recent content by bowker

It was the laptop I was using, I’ve tried it at home and I get as far as Completed File transmit. I don’t get the System Update message, but just trying the different FW’s. Just tried one and the camera seemed stuck on 192.0.0.64, I could ping but nothing else. Another time I tried leaving...

Thanks Alistair, I've managed to setup Wireshark and grab some traffic: 18 8.881541 192.0.0.64 192.0.0.128 TFTP 84 Read Request, File: digicap.dav, Transfer type: octet, timeout=5, blksize=512 19 8.882507 192.0.0.128 192.0.0.64 TFTP 74 Error Code, Code: File not found, Message: File not found...

Thanks Alistair, I have checked on a couple of switches and an NVR and it's pulling about 5w on POE, link lights are on. I have managed to get some success with TFTP on 192.0.0.128 and the device pinging back on 192.0.0.64. Device[192.0.0.64] test tftpserver I have tried a couple of...

I have a second hand 2cd4a26fwd-izs/p camera, I have hooked it up to both an NVR and a POE Switch, it powers up and you can see the infrared lights come on. However when I load up SADP I get nothing, I have tried TFTP to no avail. I have tried the factory reset button and that doesn't appear...

Doh! 11-08-2015, 09:58 PM Watch out for the 'Region setting via ONVIF specific to Hikvision' new feature. Could have a bad effect on your Chinese region cameras currently connected as ONVIF to avoid 'language mismatch'. Anyone tried that yet?

I am trying to get a Chinese 3145 working on my Hikvision DS-7604 (v3.4.0 151103) At another location I also have a Hikvision DS-7716 (v3.3.8 151222) and I can setup the camera as ONVIF and it works fine. On my 7604 at home if I set it up the same way at home I still get a language mismatch...

I have a Chinese DS-2CD3145F-IS V5.3.8build 160108 which is coming up with a language mismatch. Is it possible to hack it so the NVR will see it, will I need to find 5.3.8 CN to do it? Thanks