Perfect, both cams now up and running.
One last question, I promise, The 2nd camera, i changed the ip address before i changed the language set from chinese to English, so now it says the day in chinese on the corner of the screen, how can I log back into the camera and change this now i have...
You sir, are my hero!! It works LOL. Amazing. Now I need to try and do the same for my second camera!! What Ip address should i give the next one do you know?
Thanks again, you have saved me so much headache!!
So, I spoke to Annke via email and they sent me this guide, which i followed,
Annke KB - How to connect onvif camera to NVR via the router ?
And now that my camera and my nvr are both directly plugged into my router, i was able to detect the camera via the NVR and then add the device to the...
Hi, So far that has gone amazingly, but I got a bit confused when you mentioned to look out for the colon on the ip address, So i have attached what i see when i look at the identification screen, your help is much appreciated... Thanks
They do both support ONVIF. This is mentioned in both the camera guide and within the NVR it allows me to specify this too when trying to setup cam manually
Hi, Thank you for your reply, I have only tried one camera for now. I have attached the guide for your reference, thank you again for your help. So do you think I need to do something about the cameras setup whilst i have it plugged into my router directly?
I really do not know what that means...
Hi,
So before I start, I am a complete newbie, so apologies in advance if what I say is not techy or correct but this is what I have done so far....
I purchased a Annke POE NVR, I have it connected to my router and I have purchased some generic POE PTZ cameras from ebay. I have connected the...