Recent content by Eagle55

I will have to go to the site and look at the playback, and I'm not sure to what extent this has happened but have caught it on two occasions so far and a different camera on each. I know I have mostly the one model of Dome mentioned above but know I have one varifocal dome and one turret...

I am using a Hikvision DS-7616NI-E2/8P (Firmware V3.4.82) with 8 channels POE that plug in directly to the NVR and the other 8 via a Ubiquiti link that the NVR accesses the cameras that are on the LAN. Currently only have 4 cams on each type of input with a total of 8 camera. I have had a...

Probably a little late to help but, I have run similar wire runs successfully by using a variety on these techniques. Since you are putting a junction box on the outside I would probably try first with a one inch hole from outside into the wall.... a 3/4” or 5/8” hole from the basement into the...

The problem is I want to make something easier to use and evolve from the Lorex analog system thats been for a couple of years and get it switched over to IP cameras like the new system at city hall. I don't have time to get the link up just yet but want to have the new camera in place for when...

Found a picture of the camera position for reference.

Hi, I have a 2.8mm Dome type camera mounted in a similar position. Although it is really hard to be that close to the area that you want to look at and get all the way to the ground, it still allows for a good picture. I see the trees that can block some of the view but maybe a little bit of...

I am having difficulty getting a stand-alone system to operate the way I would like it too until I can get a wireless connection established. I am replacing a crude stand-alone system that used a Lorex DVR and 3 cameras mounted on a pole with power. System has operated for 2 years and done...