I've done a Firmware Update to my
Dahua IPC-HUM8230P
I don't know if I took the the right firmware I'm not sure,
Since I've updatet I coudn't do any changes in the configuration.
The Cam does a reboot then.
It does also a reboot every 5 to 10 minutes.
So far I've confiigures a serial connection...
No
http://192.168.1.xxx/onvifsnapshot/media_service/snapshot?channel=3&subtype=0?
everything after
http://192.168.1.xxx/onvifsnapshot/...
works with channel 1, I've tried up to channel 8, even
http://192.168.1.xxx/onvifsnapshot/trallala
and
http://192.168.1.xxx/onvifsnapshot/
work with channel 1...
I've another problem.
I need to get a picture over onvif for my homepage and after a long time of searching I found this:
http://192.168.1.xxx/onvifsnapshot/media_service/snapshot?channel=1&subtype=0?
The problem is I can't get a picture of the second cam. It always shows the channel "1"
I took...
I´ve bought a JSK-720P cam at banggood. No ir, no wifi, no zoomlens. firmware V5.00.R001.00023650.10010.248200.0C , build 2017.01.06.
Anyone an idea of http address for snapshot?
this doesn´t work
http://192.168.xxx.xx/webcapture.jpg?command=snap&channel=0
the rtsp stream works...