Recent content by Erik2b1

Bump

Anyone?

I have a bricked SD22404T-GN. I have already tried about 50 different Firmwares, but non off them working. The camera is booting and does his pre start with turning the Lens but reboots after that. I found a thread for a firmware that i haven't tried yet, but the poster is not responding to my...

I have TFTP finaley working for the Dahua SD22404T-GN but struggelinog to get the right firmware on it. i have tried the oldest one I could find (was also in a post) and the latest one I could find, but I keeps going in a bootloop. I’m getting success every time but no go. I think it’s a...

Thanks, Will do that. As soon as the adapter is in i will give it a go again (no luck with a RPi, but that could be a linux noob thing ;-) )

I have a SD22404T-GN that is not accessible. With wireshark i see that it's advertising on the network but the easy Tftp solution is not working. I have ordered a usb ttl dongle so i can try the uart solution. 1 part of the instructions is not clear for me. do i need to connect all pins to the...

Got it working! took some time but it's working. Installed a new MCU file from a link found on this forum and the v4 sip version firmware. It now works. Thanks so far!

No, luck :-( have installed the version that I received from Andy. I think something is F*cked up in the system. pressing temper switch on the back doesn't reset the device. a reset from the VDP software doesn't trigger also a full reset. Pressing the call button doesn't sent a signal as it...

Thanks Andy, I will download it and try it with fingerscrossed

Hmm Ok, i also had sent a message to @EMPIRETECANDY and he told me that this is the latest General_VTO2000A-MCU_Slave_V3.001.0000001.1.R.20190505.zip But I'm a little bit scared to install it as soon as I have found it. I already bricked it once ;-) Let's try first the reset and then move forward

Yes I already tried that, but didn't check if it works then. I'll trie that, but I have to go there to do it. will be Friday at the earliest. Thanks so far, but what's you oppinion about the firmware that is used?

Hi CC, the NVR is the NVR4104-P-4KS2 and I did a simple motion detection and that worked with no problem, no router changes or so. got a alarm after a few seconds. I didn't use the firmware for the VTO2111 that's a different story ;-) that one is working. it just the VTO2000A that's being a...

Hi CC, Sorry hoped that it was all clear lol. if you push the button there is no push to the App. Old app is also not working (never got it working with that one, have a other VTO2111 and that one didn't work as well with the old App) In the new app I can set the alarm with no problem, it's on...

Hi All, i have a problem with a VT2000a. I want to receive push messages in the DMSS App. I tried tons of things but it's not working. The VTO is online and working. It's also connect to a NVR and I see a video stream. When I add the VTO to my DMSS app I can connect and see video. I think it's...

Witch Firmware do I need voor de IPC-HDBW4431F-AS? My Dahua NVR sees this camera as a onvif camera instead of Private like my other Dahua camera