Recent content by Franklin Morgan

Thanks again everyone for the assistance! Played with this thing for a couple more hours last night and still no success, but I think I understand it better. When trying to change the ip addesses of the cameras to match the PoE ip addresses the SADP software says Device Rejected. I noticed...

Thanks! OK, as you can see the addresses are different than what SADP shows...so I need to change the NVR to match what is on SADP? Thanks again for the help everyone.

That makes perfect sense! Here is a couple of screen shots...my girl couldn't figure out how to show the full ip of the camera but I have included a couple of individual shots...

Thanks! I am going to upload a photo of the camera ip addresses on the NVR, they are different than what SADP shows I think that is what is confusing me!

Thanks everyone for the reply I will be sure to give everything a try. pmcross I would assume I need to uncheck the DHCP box on the NVR. Any chance you can give me an example of the ip addresses I should use by looking at the screenshots? Correct me please if I am wrong but I need to go into...

TonyR thanks for the reply! I'm not at the store but I had someone run the command and it shows 192.168.22.107. Concord I don't have that program but will download it when I get to the store and thanks for the reply!

Thanks for the reply, yes the PC is plugged into an empty PoE port. The NVR LAN is running to a switch. The first two positions on SADP shows two iPv4 addresses one is the switch and the other I would assume is the internal NIC card address but that address is not matching anything.

Hey forum, looking for some assistance on a HIKVision NVR camera setup. System was up and running for almost 8 months with no issues and we lost power and once it came back up we received the "no link" message on all the cams. I even ordered a new system and after I set everything up I have...