Recent content by gmo78

Yes exact, it is accessible from the internet because of port forwarding. Port forwarding is the fastest option to show all the cameras using fast android apps like "net eye camera". Unfortunately I can't change firmware on this Chinese camera.

I have a 2cd2335-i V5.3.3 (from ebay) and few days ago it stopped to work on my NVR. Tried to enter through Internet Explorer, but it refuses the password. Tried to change the password using sadp and did not work. Using the hikvision password reset was a success and now the camera works. Thank you.

At the moment it is working with POE.

I have noted it is isolated, so I checked all the combinations between the pins (es. 1 with 2, 1 with 3 etc.). Anyway, after all this assembly and reassembly of the connectors, the camera suddenly started to work (heard the sound of the relè). Looks like a fault on the flat cable, I can think...

I tried also the Schottkys as your suggestion and they looks like to be in the specifications (infinite ohm on one way and about 300 ohm on the other way). However I powered the pcb with a normal power from poe. Well on the left pins of the transformer I can read 48VDC while on the right pins no...

Well I explain better what I checked. - First test, the internal molex connected, the external female rj45 connected to a lan patch for make the check easier. The result is as written before: beeps with white orange and orange, white-green and green, blue and white-blue (white orange is tx+...

Thanks for the answer. I found a component with the label SH 1.5A just over the transformer (in my photo, this component is in the shadow of the transformer) but, unfortunately, the tester shows 0 ohm. I did not check the shorts, you right. My tester beeps with the pins white orange and orange...

After a fault on my gutters, the junction box of my 2cd2042 (powered by poe) was submerged by water and the cam stopped to work. Using the cam with a 12v power it works, so I supposed the POE pcb has one or more burned fuses. I dismounted the cam and checked the pcb, but I didn't recognize any...

I had to add the wanscann on port 554 as you said, with generic rtsp (the stream path had to report the stream 1 written in this way: /1). The NVR got the escam Q8 much easily, while the other 2 cameras haven't rtsp stream.

Well I have an Hikvision nvr-108m-a, and 4 cameras of different brands, 2 of them support onvif protocol. I have to say that this nvr is compatible only with the 2 onvif cam (wanscam hw0052 and Escam Q8), moreover the nvr can't support motion event notification with none of them. Both cam have a...