Recent content by Goldnut2

Thank You - I have something to work with now. Will try just about anything once.......sometimes twice ;)

Thanks - Do you have the bypass enabled or off? All I can find online is that it shuts off the wifi when bypass turned on!

They are wanting to access from both Wan and Lan - Sorry I missed the answering.

There is no Cat 5 connection to the Starlink unless you purchase an adapter and bypass(shut off the starlink wifi)

They had a previous provider and changed as it was very inadequate. Connection was intermittent and the DVR system was tied into the home router/network. Starlink was a major improvement for them. We just have to figure a way to get it tied to the network without disabling the Starlink wifi.

A friend in a very rural locaton has purchased Starlink system. It appears if one disables the wifi from starlink to bypass you loose all wifi from Starlink having to deal with old router. Old router has limited/less range than Starlink. My question is as follows. Will the DVR8-4575 accept a...

Thanks - I shall start looking ;)

Another UPDATE - The camera that seemed dead was not so dead after all. There was a rats nest of cat 5 cables in behind the NVR. I prior to moving marked all the cat 5 cables and plugged them in with one camera not working. I shut the system down and pulled the NVR out of the protective cooling...

Looking for recommendations for a UPS to use with a TruVision 10 and monitor. Not being a mathmagician I don`t know what size of UPS to get - Any suggestions here.

UPDATE: Well big thank you to everyone who had input. This has been a big learning curve for me. Not quite done yet. I took the NVR back to its home this AM and put in place. I was still having a no answer to password reset as I was getting at my house. I had taken my laptop with me and decided...

I do not know how to upgrade or downgrade the firmware on the cameras - part of my being here. Is there information that may assist me?

The cams are hard wired - Is there an easier way to extract the information fro the cams? I have no video when the NVR is plugged into a monitor via HDMI. I can access only by PC and SADP only so I am going to have to redo everything from scratch by the looks of it. Is there a readme or web...

I am kinda between a rock and a hard spot - I can only connect to the network at the condo with wifi. I don`t have a router there. Suggestions?

Thanks - need a bit more clarification. I have the NVR at my home - camera`s are 1/2 hour away. Does the NVR need to be hooked up to camera`s while doing the TFTP or can I do it here. Will it update the NVR plugged into a camera poe? Just a bit of a dummy as not working on with this before...

Another question - If I remove the drives will the NVR take the TFTP update?