Recent content by gzn

Today I tried to do some test again on the camera and I found that the main stream worked perfectly (perfect image) for a few additional seconds and the the camera self-rebooted. The camera worked all the time in a fixed position at 25-30 celcius degress. Could it be a temperature problem or bad...

Hello, I have two HDW5231R-ZE, but one of them have been self-rebooting by no reason a couple of days ago. The camera stay just a few seconds online. I already read Andy's topic about firmware versión 2.800.00000016 and its problems but I have not upgraded firmware since 2.800.00000010. I...

I was using yahoo, now gmail works perfect. Thanks

A couple of weeks ago I bought 2 IPC-HDW5231R-ZE cameras and everything was working fine until last Thrusday rained and I got over 70 email notifications at night. Since then I don't get any email notification cause both cameras cannot connect to gmail smtp server. I tested them using another...

When I bought the cameras I just had DC power supplies. Then, when I configured (saving of course) and connected them to use my router I plugged out and plugged in the power and the cameras did not work (non IR light at night), so I supposed that was a power problem, they "seem" bricked. Then, I...

Today I bought 2 poe injectors and I found the reset button behind the sd card slot. Holding the button for a few seconds I finally did reset them. Now using the poe injectors the cameras keep the configuration between shutdowns and startups. Very odd indeed.

No voltage variation, no lightning, Tomorrow i will buy poe power injectors to try that option.

Yes, it provides ~ 12.3V, even I tested with another one and the problem continues, thats why I presume the cameras are the problem

I dont have a poe switch at the moment, just a DC power supply 12v, it has a 1 meter wire so I dont understand what could happened if I configured them eith the same unit. Could I burned them when i just pulled off the power supply the last time? Maybe a broken configuration state? Factory reset?

My router give them dynamic ip addresses and everything was fine until I put off the power supplies. Then when I tried to put them online again I cannot see any network activity scanning with wireshark. I suspect that maybe is a power problem (no IR lights when I cover them), that is why I was...

First of all, I'm new here. Recently I bought 2 Dahua IPC-HDW5231R-ZE cameras. I configured them using a DC Power supply 12V 1.8A (positive center) and a straight ethernet cable, initializing them in 192.168.1.108 and changing from static ip to dhcp. They were working fine until I turned off...