Recent content by Heire

ok i found the ivs page on the camera, didn't look at the "home" tab like on the nvr :) everything seems ok as on the NVR, nvr config is correctly pushed to the camera. I've checked the IVS search in the NVR and the strange thing is that it seems to be linked to the day/night schedule in the...

I just got the color4K-T installed and after some fiddling of the parameters it gives a very nice image, so i started with the IVS parameters but encountered some strange things, not sure to what this is related but perhaps other people can relate. So I've got a NVR type NVR5216-4ks2 with some...

Your installer is partly right, the IR is turned on cause the car plates are overexposed. It might be too strong but you should be able to adapt it in the gui or it is fixed depending on the model. For the rest you'll have to play with the settings to improve the view during night

Hey, 3d dnr creates a nice picture of your environment and if that's what you want the good. But any moving subject will be ghostjng/bluring cause the camera wants to make a nice picture but can't handle the change in pixels properly. Hence 3d dnr is bad if you want to capture moving objects...

Nice review and a good comparison, however can you tell if you had 3d dnr on or off? Since I see blur in the moving object, it tells me dnr is enabled. How much % is it configured? 3d dnr is nice but it totally makes the image too nice and give a wrong view of the area. I test pretty much...

I have a 8232 running on 4.66w according to unifi. I have a 5232 ready to use but hadn't had any issue besides initial config.

Hey, I have a unifi 24ports with 1 camera connected and works without problem. Still waiting on my other cameras but then one will be connected on a 8 ports. All I had to do was log in to the camera on the same network, switch to dhcp and done. The config tool doesnt work at start cause you...

Mostly do have 0-30v 2A as specification, so a bit of a guess what is allowed. It's only stupid that it triggers on a no for your case, a nc would allow to directly trigger the relay. Now you need to invert that to trigger the relay, or use an inverted relay that triggers on open contact...

First off you need to know the power specifications of the relay on your nvr, you will need to connect the common with a 5/12v/24v psu. I don't really understand the reason of the connection between first and second relay? Why not connect nvr directly on the 2 relays.

Depends on your antenna specifications, but its an omni antenna so it sends signal in mostly horizontal angle. Vertical too off course but less. But signals reflect overall in your house, so its hard to say how they go in your house. Try turning 180 then the antenna is sending more out...

Hey Andy, any idea on a new firmware for the 8 series? 8232 for example. Thanks

I had a similar problem but I just logged in directly on the camera. For the first time the camera needs a new password, thats why it fails with the config tool. In general I always log in on the camera

Hey all, So I've been around on the forums for some time but never really took the time to buy me some cameras till now In my profession i work a lot with cameras but more with a-brands, although I've been working with some hikvision and dahua cameras but in lesser matter. So I've always been...