Hi All,
If you go into the code project AI explorer and go into the faces and hit the button that reads "Registered Faces" if you have Registered Faces in there, it will recognize faces as those names. You must erase those names.
I found the answer! It's in zones! Make a zone . When you do. It will collect the data and start recording unknown faces again and won't stop. My zone is A and B. I have a 6 second trigger
Hi All,
My Dahua VTO keeps turning on and off . The alarm goes on after after about 2 minutes. I have switch POE cables. I even held down the tamper button until I hear a dial tone, to no avail. Also, my VTH android can not be found on Config tools.
I fixed it! I had put an sd card into the doorbell, then removed it. After trying to figure it out. On the monitor I formatted the card and Everything worked.