Recent content by Homer51

Ok thanks for your help

in admin or 888888 743772 doesn't works for date 01-01-1970- 21:41

i remove battery for test, without success (it was too easy) I can't change date, because i don't have admin access !

Thanks ! But no works, my date is 01 01 1970 21:31

Thanks for your reply I can't get password back, no solution given to me it seems. For super password, i must bought it right ? do you have a link for that ?

Up, nobody to help me ?

Hi, I've got a problem since few days on my NVR dahua, model hcvr5108he-v2 firmware V3.200.000.0, i can't access anymore on it. Admin and 88888 password seems to have been changed. I try to login in telnet, but same problem :-( In Web, same. I try the DVR password tool but doesn't word...

Ok, Thanks for your support. Making some test with putty. Trying to find this TX ! For you the RX is on TP6 or TP7 ? or i must found it too ?

i receive my usb TTL, so i can begin test, any suggest to begin test ? Other, for my lens black module, Jack propose to sell me a new one for 180 $ without ship, expensive..

Ok, going to have a look from my Raspberry's accessories, maybe i've got something. Other i will buy one on the net. expect cms light off from module cam is caused by a firmware crash and not a hardware problem. i will test again tomorrow all card linked themselves outside the dome to see if i...

Hi, I read your post yesterday, very interesting ! Not yet, for that, do i need an RS 485 usb cable ? or modify an usb cable ? if you have a picture of the cable it's welcome ! After that i will test. Like it seems neer my problem, lan link switch on and blink orange (100 mb) For now, i...

Vendor don't answer anymore at my email since long time..

Here is some new picture of the imporx Huisun 20X cam. CI board, tested most, CI cam seems to be dead, or firmware bricked.. Any idea where can i find a KS20Ic3 camera, or similar, not found similar on ali.

I test today to run the ptz cam with and without black cam module connected. Connected, Router lan is on and blink, like a cam ok, but no ip present on sadp or router no led on Ci cam module.. Black module deconnected, no led on router. So, firmware come from black module. For the problem...

Hi, For checking Ip or Mac adress on router, even done it, without success. I've got a lot of devices, but sure that cam is not detected on any adress. Ip scan range is done too, on default Ip range, and previous IP static adress. Can somebody tell me if the motherboard of the black module...