Recent content by Ispy

yea

i did not write the error code down. first try it failed, when i read the comments on amazon there were numerous comments about even when it worked PTZ was not available. their instructions i followed had me set specific camera and tweak the stream http code. once i did this it seemed it was...

well mistake #2. got that camera and of course at first BI did not connect. found there are specific settings to add on camera config so i used that and it killed my BI server. now i cannot get BI to load. anyone know if there is a safe mode for BI? crazy. lessons learned...

man my 3d printer.... i gave up monitoring that thing long ago lol.

Thanks, you are correct - i use BI. fairly familiar with most of them dealing with an app. one thing - i hated it, others might like it but this dam REO once it booted started telling me what to do in like 6 different languages! it was loud and it was 6am lol. finally had to stick the thing...

thanks. I was actually just looking at that one lol. I did not have high expectations on the Reo but man. my 10yr old foscam works better. i will give this one a shot.

I have a need for a PTZ in a close up scenario - closet. Can't seem to find anything decent and looking for recommendations. I ordered a Reolink 5MB Super HD PTZ and it sucks horribly. thanks

thanks again, that did it!

good catch. thanks, now I just need to see if i can pass credentials in a command line on another website. i use ActionTiles for Smartthings and pull camera streams for their web interface. appreciate the help!

hi, i have a question on setting up a user. i may have a misunderstanding of its use as i cannot get the desired results. i setup a user and set it to NOT admin. in addition, i selected certain camera groups that do not include the camera in question. when i test this user with the mobile app...

just an intellinet unmanaged poe gig switch.

OK, first off I would like to thank you all for the information you have given and asked for. I was working to prep a large response as I tried other steps for troubleshooting and in the process have come across what appears to be a fix however I don't know the true issue. As I did some...

sure. package/cores running about 55c on average. compared to my system that is working which is 82c on average. don't think this is an issue. running one on wifi side works fine. something is flaky on that LAN side.

Ok. did you see my CPU load? 9% is not considerable in my opinion. and that was with an RDP session open too.

correct, hardwired for cameras only. as for cpu, i will check it but i do NOT use local console. i ONLY use web interface from remote pc unless i am doing camera changes.