Recent content by johnjm

Hi All, was wondering if anyone could help. I have 4 of the exact top201 cameras (6510 type) with IR. Day vision is fine, but night vision on two of them (newly installeD) are terrible. Same firmware, same network and camera settings. Any ideas?

A firmware upgrade solved that issue for me. It looks like you have an old firmware from late 2014.

Choose generic rtsp over http or tcp: http://192.168.1.12:554/user=admin_password=12345_channel=1_stream=0.sdp

Thanks don, I tried it a few times and it worked. Picture looks great again.

Hi Don, have you encountered an error with the IR Cut filter that is stuck? It seems that one of the cameras is stuck so that the grass now looks pink etc, whereas 2 days ago it was fine.

It should have worked because mine did it perfectly. Did you reboot afterwards?

Don, I would just like to thank you VERY much for the assistance. The telnet command worked and I now have access to the camera. It is great to know that helpful persons are out there and I am sure to be on this forum more often because of the great help! Cant thank you enough!

Thanks Don, I'm in the office right now and will attempt this as soon as I'm home :)

Thanks again Don :)

Thanks Don, will give it a try. I've already ordered a few more like this and under other brand names to use. I haven't searched the entire thread but I also like to access these via my phone and to bypass the NVR by doing so. What is the best protocol to use as I currently use IP Can Viewer...

Hi Don Correct, I have had access in the past and the bad camera did work briefly. The error in device manager is caused when I try to log into it. Either through the http port in IE or via device manager. I have also tried to disconnect the good camera and access the bad and still no luck...

I looked into the system logs for the application: Log Name: Application Source: SideBySide Date: 5/24/2015 9:37:21 PM Event ID: 33 Task Category: None Level: Error Keywords: Classic User: N/A Computer: WIN-LT3MBBARUEB Description: Activation...

PS I'm from South Africa :)

Forgot to add - is there a way to do full reset in telnet as I do have full access to it.

Thanks for the assistance. Here is the error of the reset tool: Here is the error in devicemanager: Here is the version information. This I obtained from the one working camera (IP 192.168.1.218). They are exactly the same. Last but not least, here is a picture of the board in question.