Recent content by jt3079

I have rechecked all settings on my NVR GUI and found that I forgot to tick D9 camera on Camera - Motion - IPCamera9 - Setting - D9. After I ticked on D9, D9 camera starts to record. Thanks for your comments and help.

See the attached schedule and motion detection settings.

Thanks to badmannen and alastarirstevenson. I checked the settings of D9 and D10 cameras (both cameras are DS-2CD3132-I) as follows: Camera Settings Basic Event Enable Motion Detection Checked Enable Dynamic Analysis for Motion: not checke Configuration...

I recently purchased a NVR (7616NI-E2/8P) with "AARR" in its serial number. The NVR has the firmware version of 3.0.10. I have three cameras on the local network. All three cameras are on motion detection and two of the cameras have recording, but one does not. The settings on three cameras are...

I recently purchased a NVR (7616NI-E2/8P) with "AARR" in its serial number. The NVR has the firmware version of 3.0.10. I have three cameras on the local network. All three cameras are on motion detection and two of the cameras have recording, but one does not. The following is a portion of...

Hi @SLR, I have Hikvision DS-2CD2632F-IS. The camera was bricked when I tried to upgrade firmware from 5.2.5 to 5.3.0. I tried to downgrade the firmware and did not see "System update completed" either. When I run SDAP tools and it shows "V 4.0.8 Byuld 150401" and says 192.168.1.64 IP...

I was also the dumbest person to upgrade the firmware to 5.3.0 from 5.2.5 for DS-2CD2632 camera. The rebooting took forever and did not complete. Now I could not see this camera on SADP. From the messages above, the camera can be unbricked using the TFTP. Where can I download the TFTP? I...