kickstart24's latest activity
-
Kkickstart24 replied to the thread Ethernet wire pairs faulty.Thanks. I have 10 cameras installed. For 8 of them, with a camera on one side and a tester on the other, I get all eight lights active...
-
KI have a Cablematters 24-port patch panel with inline keystones that connect the ethernet wires from my cameras to my POE switch. I've...
-
KI've been doing some diagnostics on my network. While plugging in a cable tester on one end and my dahua poe camera at the other end, I...
-
KIs it common for a camera to have a few NoSignal counts in the BI status log? Or is this usually indicative of some kind of problem?
-
Kkickstart24 replied to the thread Camera No signal.Thanks. Yes, I'm trying that first. When I say I am unplugging/plugging the cable, I'm not actually unplugging and plugging the cable...
-
Kkickstart24 replied to the thread Camera No signal.Thanks. I guess what confuses me is if this was a cable problem, why would unplugging and replugging the cable at the switch put the...
-
Kkickstart24 replied to the thread Yellow circle and blue bell?.Can't find the yellow circle explained
-
KWhat does this small yellow circle in the top right of the camera preview mean? What about the blue bell?
-
-
Kkickstart24 replied to the thread Camera No signal.Would a cable tester show if there is a problem? Or can that give you a false positive (cable is bad, but tester shows its good)?
-
K...and make sure you terminate it the same as the other end (T-568A or T-568B) or re-terminate BOTH ends the same ("B" is most common...
-
Kkickstart24 replied to the thread Camera No signal.I'm pretty sure its going to be a termination issue. I've had a lot of problem with the cables. Can I just cut off the cable right at...
-
Kkickstart24 replied to the thread Camera No signal.Yes, I did use dielectric grease. Do you have any recommended tools for terminating CAT6 cable? The cable is pretty short outside, so I...
-
KI have a T54IR-ZE-S3 that keeps showing as "No Signal" on BI. It was working great for the first few weeks, but now I keep getting this...
