Just "motion". I did see that it has a driver specific to this camera (I was using the generic one). I changed over to that but havent had any time to see if that helped. I am guessing not
I am confused by Hikvision motion detection. With the settings below I expected that motion detection would only be triggered when a human or vehicle was detected. What is happening is that any motion is trigering recording on my Synology Surveillance Station.
First post but have been trolling for a while...
I just got an Acti B97. Other than the IP address it is pretty much at its default config – 10.1.1.212. as you can see from the screen grab below, I get video from the camera’s normal web page. When I set it up in BI I get “no signal”. The...