Recent content by maxvr6

Once i had everything setup correctly i just used the command: setenv bootcmd ‘;update’ Thats literally all i did, the whole process took care of itself from there :)

Ok im an idiot, after reading printenv i can see i hadn't set the network of the laptop im using accordingly, then went into TFTP and set the server IP accordingly and things started happening straight away! Looks like i have successfully reflashed it and there is life once more, HD and network...

Thanks for the assistance! I've run both those commands but not sure im seeing the command i need, attached the log :)

Just to clarify the reason for trying a firmware flash in the first place was to resolve the issue of the cameras constantly dropping off, i knew this was likely the high latency on the LAN but i thought id try anyway, yes this was just asking for trouble but i was getting extremely...

So i did a very silly thing and tried to remotely update the firmware on this DVR over the LAN from iVMS-4200 when i knew the LAN had very high latency... halfway through the update it failed and now the DVR is bricked. Symptoms are DVR powers on but does not boot at all, nothing from VGA or...