Recent content by Nelle

Thank you. I've just ordered some Deox which I'll try. Fingers crossed.

Thank you for the advice. Unfortunately this Hik vision camera has the connection inside the backplate and it's a fixed female RJ45 solder connected to a PBC. On closer inspection there is no corrosion inside the RJ45. The water only got into it once I had moved the camera and undone the back to...

I have had this problem repeatedly with these cameras. They were installed correctly so I was puzzed until I realised that tiny nicks in the cable were allowing water to travel inside the cable to the camera. Everything worked fine until I moved the cams to a new position which then allowed the...

Thanks for all your help, I'll let you know if it fixes it.....

Hi I've had my system remotely connected to this morning and it's looking like the nanobeam has a problem and can only works on 10Mbps instead of higher. When the settings on the nanobeam are changed to above 10MBPS the system crashes Being sent new nanobeams, hopefully this will sort the...

Each switch is seperately hard wired to a wireless link which is then has a single cable back to the NVR

I currently have 4 cameras on one switch and 2 on the other switch, although one of these only runs for half an hour or so before dropping off completely. All the cameras are freezing and jumping. I'm working my way through changing all the cat5 connectors, just in case one is poorly connected...

Hi guys It's been suggested to me that the problem is being caused by the NVR. I have a K series and I'm bing told that with the amount of 4mp cameras, the long lengths of cable and the wireless bridge, the K series struggles with the amount of data and an I series is better equiped to deal with...

OK I will give that a go and let you know if it fixes the problem. If the nanobeam is to blame, is there anything I can do or do I need to find an alternative to get the signal across without wires ? (It beams across my track into the property) The nano beam is rated 450Mbps over 15km and mine...

Hi Alastair Please forgive my ignorance I'm just managing to muddle my way through all this as I don't really fully understand what I'm doing. If the full size uses the main stream and that's what's jumping. How do I correct it please ? Nelle

I've just noticed something very odd. When I've got multiscreens up on my NVR monitor then the jumping seems to be minimal. but if I go into single screen mode the jumping is back. So when I have single screen jumping is really bad. When I have 1 + 5 the larger 1 is jumping but not the...

I've lowered the fps on all the cameras to 10 and changed the video stream to sub stream, again on all cameras. Still getting jumping on live view but no longer on playback, but picture quality is now pretty blurry. On live view now getting jumping of around 6 to 15 seconds and it's frequent...

Just a quick question. Should all the video streams be set to sub stream ? Thanks Nelle

Thanks Guys, I'll try what you've both suggested and let you know how I get on Nelle

Hi I'll try and answer as best I can. All the equipment is Hikvision; The NVR is DS-7608NI-K28P 4 cameras are DS-2CD2H45FWD-IZS 2 cameras are DS-2CD2345FWD-I Both 4 port switches are wired into a ubiquity nano beam bridge, which is then wired into the NVR. All the cameras are wired back to the...