Recent content by rudiau

Damn "1) Go to System - Security - Private Protocol Auth. Mode Change from Security Mode to Compatibility Mode"" Setting doesn't exist on my NVR4104.

Went back to disconnecting clock/bios battery. this attack went well. Left it disconnected for about half an hour. No workee, goes straight to password page. Twas a long bow, I know. :(

Hmmm yes, about that clock/bios battery. The battery is a CR1220 watch battery. It is welded to both bracket holders which is then soldered through the board.(so soldered both sides). Tried with a solder sucker but no success. Good luck to anyone replacing that battery down the track.

Had a thought. When you first receive your new NVR and power up, it asks if you are inside China or outside China. If you choose outside it then asks you to select a country. It continues on then with setting password and questions etc etc. I have tried a few factory resets but it always opens...

I think looney2tns has nailed it. I think I'm going to go the BI PC route.

Hi dudemaar, I was able to access the cameras by bypassing the NVR altogether and using Smart PSS on a PC using the password entered when setting up the NVR.

Oh dear, nice expensive little trap for newbs. Thanks for your help looney2ns, you too bigredfish.

Situation, New DH-NVR4104Hs 4P 4KS2 POE version V3.216.12SD.000.0 4 x HDW4631c-a version 2.622.0000000.23.R LAN TCP/IP 192.168.20.108 Switch 10.1.1.1 Cam 1 10.1.1.65 Cam 2 10.1.1.66 Cam 3 10.1.1.67 Cam 4 10.1.1.68 The problem is the NVR auto registers all the cameras but they all come up with...

Hi, Does the Dahua DHI-NVR4104HS-4P-4KS2 still require plug-ins for web service/interface with the latest firmware? Thanks