Hi. That is very helpful thanks. I'll grt into the settings and try that. Particularly the UPNP. I did have port forwarding turned on in the router. I think at first to set ip the cameras on Angel Cam but scrapped that because it was too much bandwidth (I thought) because the cameras keplt...
that is a good idea!!! Also I just looked at one of those manuals - loads of information there. I don't understand it all but I can have a proper look later. As I say I did have it working for a while so I think I essentially did it right but then it all started crashing! One camera after...
W
Hi - I have seen the manuals - the ones for the cameras are very basic.. unless I am not looking right! I will have another look
ith regard to what I have done so far.. well I thought I knew but have gotten a bit confused. I have hooked up the NVR to the cameras over PoE. the cameras have...
HI Marku2 - I have posted this on the main board and here is the link.. you will see that I have posted some photos that show all the makes and model numbers of the two types of cameras and the NVR (in reply to someone called Matt)
With regard to what I have done so far.. well I thought I knew...
HI Matt
I response to your question I have now photographed all the boxes which show all the model numbers etc. There may be something there that you or someone else recognises. Someone else asked me what they are and what I had done so far so I will probably reply separately to him so he...
HI - I do know that the IP's are all different, I am going to reset them. I am just going to reply to the chap who asked me what make/model they all are and what I have done so far.. it's hard to describe exactly what I've done so far but I'll give it a go!
Thanks
Tony
This is all rather worrying.. I'm reluctant to try to take it back... i've had it a couple of months now and the cameras are installed around the place. Can I factory reset everything and start from scratch in consultation with you guys?