Recent content by truxntrax

Re: Recording of stream Hi, it's the 6510. I flashed the firmware as per the instructions by ttyusb. That all went ok. All the files were deleted and rewritten OK. However the cam is still not happy and the process sophia crashes with a segmentation fault... I think the water must have...

Re: Recording of stream Hi Don, My cam has been in the wars again... This time it stopped worked which I think was due to a small amount of water ingress into the camera housing. I have dried the camera out and cleaned the board with some ISO alcohol. The camera powers back up but now has a...

I can confirm that the instructions and upgrade.img file work as directed. My camera is now unbricked and booting as normal. :-) Thanks Don and others who helped.

I now have tty access to the cam.

My TTY to usb converter is now here. Will be ready to move to the next step tonight. Will be connecting from a Ubuntu 14.04 laptop. Do you guys know what connection settings I need to connect? Many thanks

Hi, Cable ordered. Here is my firmware pre the attempted flash. Hopefully we can write a guide for others at the end of this. Likely a couple of days before the delivery gets to me- I will message as soon as it comes. (May be able to borrow one from work sooner, hopefully) Thanks

Hi, I checked the firmware and know it's correct as used it on same cam, number 2, but via the device manager software. Attached is a pic of my specific board removed from camera. Are these the right pins to a TTY connection? Also can I use this to attach to it (no serial port on my...

Hi Don. I have tried the reset utility with no luck. The cam doesn't appear on the network. The reset utility says camera cannot be found (or something similar). Fyi I was uploading the firmware via ie using the active x presented interface. The upload got to 3 blocks progress then just...

Think I may have bricked my camera :-( Firmware upgrade never completed and now the camera doesn't show up on my network. I read in the ealrier posts that shorting 2 pins on the board may reset? Any other thoughts of bringing my cam back to life? Thanks

I have a camera with this board... Therefore do the pins "reserved for POE" deal with a 48v poe injector? My gut feel tell me not and I will fry the board... However why else are there some extra pins on the P3 connector? Many thanks for the good detailed information.