Search results

Thank you how do I downgrade?

It came in the hikvison app that an update was avaible. So I updated from the hikvison app. And i got build 211101 not ezviz 211011

You see that in the picture, DS-HD1 5.2.4 build 211101 Can you downgrade the firmware on the doorbell?

Intresting does not work for me, and I have a newer build.

5.2.4 Where in the batch config do I do that? Cant find it.

Onvif is enabled but the url: http://192.168.1.10/onvif/snapshot.jpg Shows up nothing, it must have changed in the update?

How do I do that?

hm i updated the hikvison ds-hd1 to newst firmware 5.2.4 now i cannot get still image from http://IP/onvif/snapshot.jpg, does anyone know if they changed the url for still?

Hi thank you for helping me, I have now done the voltage test. a-b = 0,3 volt´AC c-d = 0,8 volt AC Testing moving the 3k3 resistor on the different points you suggested did not help at all. But connecting it like my picture below worked. And it showed off, when not pressed and on when...

I will check the voltages and report back. I got this answer from the seller of the board. " Yes, that’s actually normal. The boards had a problem with the footprint of the optocoupler, because of that they are soldered on by hand. It may look a bit messy, but every board is testes before I...

I mean the board works and is not dead. But it does not work because it shows that the button is pressed all the time.

Ok, not getting anything, and i know it works. When there is no power it does not send mqtt messages and when there is power it sends "on". But can I add the resistor on the line from the doorbell before the connections points to the mordernizer? Will that be the same?

I tested, but the multimeter just showed OL. Can I add the resistor to point a to c? E to F is so small to solder hehe. Or even put the resistor before connection to the board? Will that work with ac?

Hi thank you I upload a better picture here. I don´t know about the oxidation the unit arrived with it. I'm need to do some kind of mod because it now allways show as the doorbell is pressed. I checked with multimeter and when idle it is 5 volt and when pressed it bumps to 7,5 volt.

Can you or someone that understand explain where I need to change out the resistor on the Modernizr? See picture.

Anyway to intercept the bell button is pressed, in any firmware?

Hi, has someone managed to intercept the bell button pressed via api? Or loading a custom firmware that can see this press?