Search results

I agree, which is why I have been trying to focus my efforts on the ramdisk issue and figure out how to move it past this point.

ok so while I did try 5.4.14 it was not the version I have a completed transfer.. below is the information.. I have copied the complete serial sessions for both the successful firmware update and the results after the update when trying to boot camera normally while watching through putty.. The...

Got it. Ty. Pretty sure it is 5.4.14. The most recent. I will double check on that that for 100% and I will also take the full image so you can see more of what I'm talking about but it's literally as soon as you connect the camera and it gives you the two or three seconds to hit control-u then...

Ok so thank you again for pointing that out as you were correct and after going back looking at the notes I made the last time I messed with the serial side I was incorrect stated power and not ground. I think part of my problem was computer related as well. I have a few different laptops I use...

My mistake, the connector I made was a copy off of someone else's they had made out of spare parts. I have lots of wires and connectors from analog cameras so this was no problem. I have never had a problem in the past using this so I will go back and double check to make sure I was doing...

That's the strange part. I have and nothing comes up. I have tried all pins just in case. You only need power tx and rx right. Correct? This is all I have used in the past and I put together a little wire harness to make it simple as well.

First post so if posted in wrong area please fee free to move to correct.. Let me start out by stating that I am no Jedi master but I do have a understanding to some degree of how the Hikvision ipcams work.. As a way to create a even better understanding, I will sometimes purchase Chinese...