Search results

Alright everyone, per recommendation above and even though I tested it, it was the camera side connection. I replaced the end and it now functions as expected. I appreciate everyone's assistance here and it goes to show, you can't always trust a cable tester...

I did use 568B for all ends.

Thanks for the feedback everyone. I will put on a new end on the camera side first. At this point, if that doesn't work I will probably re-examine the line for any kinks. If I do find a 'bad' kink, will it be sufficient to use a female to female coupler and cut the kink out? (Ex. Revo RJ45...

Yeah, I just didn't do that side because I was able to test it with the cable tester this morning and it checked out. My cable tester blinks green in sync on both sides. I will reinspect the cable later today again prior to ripping it out.

500 ft. Blue 23/4 Solid CU CAT6 CMR (Riser) Data Cable - This is what I bought from Home Depot. I have another run that's roughly 100' with no issues. Just tested ethernet on a laptop, it didn't work. Yikes, I think I'll end up needing to replace the line.

Hello, Just got all my wire ran through the attic and cameras installed. All cameras but one is connected. Here's what I've tried: Replaced end on one side, not the camera side Tested with a cable tester for pairing Tried a second camera on the same cable Tried different ports in the switch and...

The kit I purchased from Costco includes a NVR. I never thought about the noise, I surely hope that isn’t an issue as it’ll be in my office where I work from. This is my private home and I’m upgrading from Arlo’s to an IP system for the first time. I purchased both the faceplate and a PoE switch...

Hi all, I have an AvertX 16 Channel with 8 Cameras from Costco arriving this weekend. My question to you all is, how did you manage to run all your cable to the NVR? It’s going to be located in my office and I was thinking of installing a 12-Port faceplate then running a short length cable to...