Search results

  1. R

    ColorVu and coyote

    I figured it out. My auth problem was due to running the curl command from Linux subsystem in windows. I switched to powershell and it works. I used the following command to ascertain the correct node and parameter syntax. curl.exe -i --digest -u admin:mypassword -X GET...
  2. R

    ColorVu and coyote

    I encountered the error message mentioned above after following the instructions in the linked post. I copied and pasted the curl command, then replaced the camera IP address with the correct one and updated the --digest -u switch with my actual camera username and password. curl.exe -k...
  3. R

    ColorVu and coyote

    Thanks that's helpful! I'll have to read through the PDF's. The curl commands don't work. I inserted the correct IP address and credentials but it gives me an error message: Maybe something has to be modified in the camera's configuration, or it could be because I'm running the latest...
  4. R

    ColorVu and coyote

    I have a Hikvision ColorVu DS-2CD3348G2-LISU and a coyote that's been chewing up the drip irrigation system on my green roof. I'm using Blue Iris with Code Project AI and would like to trigger the camera's dual white LEDs only when a coyote is detected by the AI. I've successfully configured...
  5. R

    Garbage AI

    I want to monitor the times when my three garbage cans are placed in my driveway and subsequently collected. Each can has a unique six-digit number stamped on the front, along with a barcode. Is it possible to develop a custom model to recognize garbage cans and then utilize OCR, barcode...
    • rdagger
    • Thread
    • Replies: 2
    • Forum: AI
  6. R

    Blue Iris and CodeProject.AI ALPR

    Unfortunately, I'm still only getting correct OCR results about 50% of the time. Getting more mismatches such as D to 0, 0 to O, L to 1 and Z to 7 and some characters just being dropped. What are the units for OCR_OPTIMAL_CHARACTER_WIDTH and how do they relate to the pixel size of the plate...
  7. R

    Blue Iris and CodeProject.AI ALPR

    I just switched from DeepStack with Plate Recognizer to Code Project AI running on a 6th gen i5 in Windows. So far it works, but the license plate OCR is not performing as well as Plate Recognizer. There are a lot of mismatches between Z and 2, W and H, 4 and L, 5 and S. Nonexistent spaces...
  8. R

    change serial number in hikvision DS 72xx HGHI F1/N

    Sorry I didn't keep the firmware and the NVR went to ewaste last week.
  9. R

    Day 2 IP camera foggy

    I tried to clean my older Hikvision 2CD2542FWD camera (4MP Outdoor Day/Night Mini Dome 4MM ) circa 2016. Unfortunately, the plastic is in bad shape and could not be cleaned. Can you buy replacement mini domes?
  10. R

    Day 2 IP camera foggy

    It's been a day and despite humidity in the 90's, the picture is still clear. I'm thinking I need to clean some of my other existing cameras because their pictures look relatively poor compared to the new camera.
  11. R

    Day 2 IP camera foggy

    I think I fixed it. I put the desiccant in the toaster oven for 30 minutes at warm. Then I put the bag in front of a small space heater/fan for an hour. I repaired the camera in the same room as the space heater. I powered the camera and let it warm up for an hour before putting it back...
  12. R

    Day 2 IP camera foggy

    I opened it up and removed the desiccant. How do I dry the desiccant (microwave, toaster, hair dryer)?
  13. R

    Day 2 IP camera foggy

    I installed a Hikvision DS-2CD2035FWD-I camera (3MP Outdoor Day/Night Bullet 4MM) yesterday on my garage. The picture looked great. This morning I looked, and the picture was all foggy. I inspected the camera and there is now a discoloration on the lens. I tried cleaning it but it's on the...
  14. R

    change serial number in hikvision DS 72xx HGHI F1/N

    I ended downgrading the firmware to 3.4.92. The latest firmware 4.61 wasn't stable. At first, I thought it was working, but several times during the day the NVR would just reboot. After downgrading the firmware, it has been stable, and the UI is significantly faster.
  15. R

    change serial number in hikvision DS 72xx HGHI F1/N

    Looks like the correct port is JP8 and the pinout is GND, RX, TX, 3.3V. I'm referring to RX and TX labels on the USB TTL adapter. JP3 produced the following output: U-Boot 2010.06-svn (May 04 2015 - 14:38:38) *** Warning - bad CRC, using default environment In: serial Out: serial Err...
  16. R

    change serial number in hikvision DS 72xx HGHI F1/N

    Thanks, that's very helpful!
  17. R

    change serial number in hikvision DS 72xx HGHI F1/N

    No, that sounds like it would be easier for most people assuming they have the correct TTL adapter and cabling. Which header J3 or J8 on the motherboard is the UART? Looks like pin 1 on both headers is the ground and pin 4 is 3.3V, but which pins are TX and RX? Is the female header on the...
  18. R

    change serial number in hikvision DS 72xx HGHI F1/N

    I performed a couple of comparisons. Difference between firmware versions 4.5 and 4.61 on the same board with the same serial numbers. 00090000 000901CB (459 bytes) Difference between same firmware on different boards with different serial numbers 0008F000 0008F201 (513 bytes) 00090000...
  19. R

    change serial number in hikvision DS 72xx HGHI F1/N

    I bricked a DS-7608NI-I2 during a firmware update. I found another working DS-7608NI-I2 and copied the firmware using a TL866II programmer. Unfortunately, both NVR's now have the same serial number. I made a copy of the original bricked firmware so I should be able to copy the encrypted serial...
  20. R

    People can mask USPS AI detections

    5.6.2.0 (9/23/2022) is still working for me.
  21. R

    People can mask USPS AI detections

    That's very cool. I'll check it out. So far, my current model is working so I will test it for a few weeks before upgrading to your version. Thanks.
  22. R

    People can mask USPS AI detections

    Here's where I got it: https://github.com/sstratoti/DeepStack_USPS
  23. R

    People can mask USPS AI detections

    Are you referring to the trigger break time? I have it set at 10 seconds. Seems like setting it under 6 seconds could end up truncating events. Cloning sounds like a decent workaround. Are there any performance hits to creating clones? I'm thinking I should make several clones of the street...
  24. R

    People can mask USPS AI detections

    I implemented a custom DeepStack model to alert me when the mail is delivered because my mailbox is down the street from my home. I'm using a camera mounted near the street that also detects people and vehicles (including ALPR). The post truck detection works but will fail if the event is...
    • rdagger
    • Thread
    • blueiris alerts deepstack usps
    • Replies: 169
    • Forum: AI
  25. R

    Purging cancelled alerts?

    I just started with Blue Iris and Deep Stack this week. The Alert Confirmation menu has a checkbox to Hide cancelled alerts on timeline and 'all alerts'. However, it would be great if the program could automatically delete the saved hi-res images relating to cancelled alerts in the alerts...
  26. R

    EZViz Thumbnails

    About a 1/3 of my cameras are missing thumbnails on EZViz (Both on the phone app and the website). You used to be able to manually set a cover thumbnail from the website by clicking the Cover button. However, now it returns an error message: "Setting cover failed". The phone app used to...
  27. R

    Nvidia Shield + TinyCam Pro

    I bought an Nvidia Shield 16GB 3 months ago and it’s great. Much better than our existing Apple TV and Roku. Is TinyCam Pro still the best solution for the Shield to monitor IP cameras? I have a Hikvision NVR with a lot of IP cameras.
  28. R

    Stuck IR Filter

    Hikvision replaced the camera, but I recently had another Hikvision mini-dome camera get a stuck IR cut filter (half way open). The seller wouldn't replace it because I had painted the case. I tried cycling between day and night but it didn't work. The filter didn't budge and the normally...
  29. R

    Plates were working but now overexposed.

    I'm finally getting good results!:) I switched back to the 16mm bullet (DS-2CD2232-I5) and reverted the firmware to 5.4.0. Brightness 52 Contrast 75 Saturation 63 Hue 27 Sharpness 50 Exposure Time 1/750 Gain 10 Smart Supplement Light Off BLC Area Off WDR Off Digital Noise Reduction Off...
  30. R

    Plates were working but now overexposed.

    I tested the illuminator with 3 different camera models at about 35 feet and it just wasn't very bright. At closer distances under 10 feet it helped. I think it's just under powered or maybe 850nm is not a good wavelength for my cameras or maybe the existing EXIR lights on the camera are...
Top Bottom