Search results

Did you do the static route /dual IP thing? You should run wireshark to see if you see any TFTP attempts from the camera. I wouldnt do the test inside the VM since in most cases the VM runs in NAT mode and thus you won't be able to run the TFTP server inside.

Dear Marco. Yeah, Agree with you. The SIP implementation is EXTREMELY finnicky. I've been trying it against different devices / SIP servers and it has been very hit-or-miss. You have two modes though, one where the Dahua acts as a SIP server itself so that other devices can register to it and...

Yeah. Not sure what the upall one is. The smaller files are useful to to install via tftp in rescue mode (which might be needed if this firmware is not signed and the one in your doorbell is) . Basically if the upload fails a few times it means it's unsigned and rejected (or that's what I saw)...

Hi Marco .I need to check my notes back. But you won't be able to install the big zip file. You need to open it up and look for the bin file inside. I'll get back to you asap on which firmware i used and how I installed it .

Dear @AR22 please send me a direct message and I can try to send you the firmware somehow. I have not tried logging in again, but what error are you getting?

Hi! Just wanted to follow up. Using the 3.300 version of the firmware, I was able to interoperate the doorbell with an asterisk PBX (freePBX) without any issues. The main detail is that you have to specify that the extension you configure for the VTO must send the DTMF digits as a SIP-inform...

Hello everyone. New to the Dahua ecosystem but eager player here :) I just upgraded my VTO2111D-WP to the 3.300 firmware from the dahuasecurity.com website. It took me a while cause the site is blocked from my region (Argentina) but thanks to a VPN, I managed to get to it and dowload the...

Dear @bobfather I Just ran into a similar situation.. turns out for the VTO units, the list of files to flash is slightly different: I succesfully un-bricked my VTO after doing the following: setenv serverip 192.168.1.99 (if you have access to the serial console, use this command to avoid the...