Search results

  1. C

    VTO2111D-WP bricked, won't recover

    The UART port is the smallest connector located in the lower left and the order of the pins is: 3.3v GND Rx TX. Remember to connect the TX pin of the VTO to the RX pin of the CP2102 and the RX pin to the TX pin respectively.
  2. C

    VTO2111D-WP bricked, won't recover

    To connect the PC and the VTO in LAN network is possible through a router, switch or direct connection between the two devices
  3. C

    VTO2111D-WP bricked, won't recover

    Attached file of the session
  4. C

    VTO2111D-WP bricked, won't recover

    Hello, if up to that point the configuration is correct. By UART console you can see the advance process of installing the firmware... Keep in mind the configuration steps of the network in the following link: https://ipcamtalk.com/threads/dahua-ipc-easy-unbricking-recovery-over-tftp.17189...
  5. C

    VTO2111D-WP bricked, won't recover

    Hello, after hours of research and testing, I managed to recover the video door entry. There were always missing files and other incorrect ones. I hope it serves you. http://dahuawiki.com/images/Firmware/Video_Intercom/General_VTO2111D_Eng_P_16M_V1.000.0000.0.R.20170414.zip To do this, it is...
Top